All the MFD components are gone from the header meanwhile. Only the MMC relevant data is left which makes it a platform_data for the MMC controller. Move the header to the now fitting directory.
Showing the changes to include/linux/platform_data (1 of 13 files). Show all
Unified · Split
| @@ -0,0 +1,64 @@ | |||
| 1 | /* SPDX-License-Identifier: GPL-2.0 */ | ||
| 2 | #ifndef MFD_TMIO_H | ||
| 3 | #define MFD_TMIO_H | ||
| 4 | |||
| 5 | #include <linux/platform_device.h> | ||
| 6 | #include <linux/types.h> | ||
| 7 | |||
| 8 | /* TMIO MMC platform flags */ | ||
| 9 | |||
| 10 | /* | ||
| 11 | * Some controllers can support a 2-byte block size when the bus width is | ||
| 12 | * configured in 4-bit mode. | ||
| 13 | */ | ||
| 14 | #define TMIO_MMC_BLKSZ_2BYTES BIT(1) | ||
| 15 | |||
| 16 | /* Some controllers can support SDIO IRQ signalling */ | ||
| 17 | #define TMIO_MMC_SDIO_IRQ BIT(2) | ||
| 18 | |||
| 19 | /* Some features are only available or tested on R-Car Gen2 or later */ | ||
| 20 | #define TMIO_MMC_MIN_RCAR2 BIT(3) | ||
| 21 | |||
| 22 | /* | ||
| 23 | * Some controllers require waiting for the SD bus to become idle before | ||
| 24 | * writing to some registers. | ||
| 25 | */ | ||
| 26 | #define TMIO_MMC_HAS_IDLE_WAIT BIT(4) | ||
| 27 | |||
| 28 | /* | ||
| 29 | * Use the busy timeout feature. Probably all TMIO versions support it. Yet, | ||
| 30 | * we don't have documentation for old variants, so we enable only known good | ||
| 31 | * variants with this flag. Can be removed once all variants are known good. | ||
| 32 | */ | ||
| 33 | #define TMIO_MMC_USE_BUSY_TIMEOUT BIT(5) | ||
| 34 | |||
| 35 | /* Some controllers have CMD12 automatically issue/non-issue register */ | ||
| 36 | #define TMIO_MMC_HAVE_CMD12_CTRL BIT(7) | ||
| 37 | |||
| 38 | /* Controller has some SDIO status bits which must be 1 */ | ||
| 39 | #define TMIO_MMC_SDIO_STATUS_SETBITS BIT(8) | ||
| 40 | |||
| 41 | /* Some controllers have a 32-bit wide data port register */ | ||
| 42 | #define TMIO_MMC_32BIT_DATA_PORT BIT(9) | ||
| 43 | |||
| 44 | /* Some controllers allows to set SDx actual clock */ | ||
| 45 | #define TMIO_MMC_CLK_ACTUAL BIT(10) | ||
| 46 | |||
| 47 | /* Some controllers have a CBSY bit */ | ||
| 48 | #define TMIO_MMC_HAVE_CBSY BIT(11) | ||
| 49 | |||
| 50 | struct tmio_mmc_data { | ||
| 51 | void *chan_priv_tx; | ||
| 52 | void *chan_priv_rx; | ||
| 53 | unsigned int hclk; | ||
| 54 | unsigned long capabilities; | ||
| 55 | unsigned long capabilities2; | ||
| 56 | unsigned long flags; | ||
| 57 | u32 ocr_mask; /* available voltages */ | ||
| 58 | dma_addr_t dma_rx_offset; | ||
| 59 | unsigned int max_blk_count; | ||
| 60 | unsigned short max_segs; | ||
| 61 | void (*set_pwr)(struct platform_device *host, int state); | ||
| 62 | void (*set_clk_div)(struct platform_device *host, int state); | ||
| 63 | }; | ||
| 64 | #endif | ||