/* * Copyright (C) 2016-17 Synopsys, Inc. (www.synopsys.com) * Copyright (C) 2004, 2007-2010, 2011-2012 Synopsys, Inc. (www.synopsys.com) * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License version 2 as * published by the Free Software Foundation. */ /* ARC700 has two 32bit independent prog Timers: TIMER0 and TIMER1, Each can be * programmed to go from @count to @limit and optionally interrupt. * We've designated TIMER0 for clockevents and TIMER1 for clocksource * * ARCv2 based HS38 cores have RTC (in-core) and GFRC (inside ARConnect/MCIP) * which are suitable for UP and SMP based clocksources respectively */ #include <linux/interrupt.h>#include <linux/clk.h>#include <linux/clk-provider.h>#include <linux/clocksource.h>#include <linux/clockchips.h>#include <linux/cpu.h>#include <linux/of.h>#include <linux/of_irq.h> #include <soc/arc/timers.h>#include <soc/arc/mcip.h>  static unsigned long arc_timer_freq; static int noinline arc_get_timer_clk(struct device_node *node){	struct clk *clk;	int ret; 	clk = of_clk_get(node, 0);	if (IS_ERR(clk)) {		pr_err("timer missing clk");		return PTR_ERR(clk);	} 	ret = clk_prepare_enable(clk);	if (ret) {		pr_err("Couldn't enable parent clk\n");		return ret;	} 	arc_timer_freq = clk_get_rate(clk); 	return 0;} /********** Clock Source Device *********/ #ifdef CONFIG_ARC_TIMERS_64BIT static u64 arc_read_gfrc(struct clocksource *cs){	unsigned long flags;	u32 l, h; 	local_irq_save(flags); 	__mcip_cmd(CMD_GFRC_READ_LO, 0);	l = read_aux_reg(ARC_REG_MCIP_READBACK); 	__mcip_cmd(CMD_GFRC_READ_HI, 0);	h = read_aux_reg(ARC_REG_MCIP_READBACK); 	local_irq_restore(flags); 	return (((u64)h) << 32) | l;} static struct clocksource arc_counter_gfrc = {	.name   = "ARConnect GFRC",	.rating = 400,	.read   = arc_read_gfrc,	.mask   = CLOCKSOURCE_MASK(64),	.flags  = CLOCK_SOURCE_IS_CONTINUOUS,}; static int __init arc_cs_setup_gfrc(struct device_node *node){	struct mcip_bcr mp;	int ret; 	READ_BCR(ARC_REG_MCIP_BCR, mp);	if (!mp.gfrc) {		pr_warn("Global-64-bit-Ctr clocksource not detected");		return -ENXIO;	} 	ret = arc_get_timer_clk(node);	if (ret)		return ret; 	return clocksource_register_hz(&arc_counter_gfrc, arc_timer_freq);}CLOCKSOURCE_OF_DECLARE(arc_gfrc, "snps,archs-timer-gfrc", arc_cs_setup_gfrc); #define AUX_RTC_CTRL	0x103#define AUX_RTC_LOW	0x104#define AUX_RTC_HIGH	0x105 static u64 arc_read_rtc(struct clocksource *cs){	unsigned long status;	u32 l, h; 	/*	 * hardware has an internal state machine which tracks readout of	 * low/high and updates the CTRL.status if	 *  - interrupt/exception taken between the two reads	 *  - high increments after low has been read	 */	do {		l = read_aux_reg(AUX_RTC_LOW);		h = read_aux_reg(AUX_RTC_HIGH);		status = read_aux_reg(AUX_RTC_CTRL);	} while (!(status & _BITUL(31))); 	return (((u64)h) << 32) | l;} static struct clocksource arc_counter_rtc = {	.name   = "ARCv2 RTC",	.rating = 350,	.read   = arc_read_rtc,	.mask   = CLOCKSOURCE_MASK(64),	.flags  = CLOCK_SOURCE_IS_CONTINUOUS,}; static int __init arc_cs_setup_rtc(struct device_node *node){	struct bcr_timer timer;	int ret; 	READ_BCR(ARC_REG_TIMERS_BCR, timer);	if (!timer.rtc) {		pr_warn("Local-64-bit-Ctr clocksource not detected");		return -ENXIO;	} 	/* Local to CPU hence not usable in SMP */	if (IS_ENABLED(CONFIG_SMP)) {		pr_warn("Local-64-bit-Ctr not usable in SMP");		return -EINVAL;	} 	ret = arc_get_timer_clk(node);	if (ret)		return ret; 	write_aux_reg(AUX_RTC_CTRL, 1); 	return clocksource_register_hz(&arc_counter_rtc, arc_timer_freq);}CLOCKSOURCE_OF_DECLARE(arc_rtc, "snps,archs-timer-rtc", arc_cs_setup_rtc); #endif /* * 32bit TIMER1 to keep counting monotonically and wraparound */ static u64 arc_read_timer1(struct clocksource *cs){	return (u64) read_aux_reg(ARC_REG_TIMER1_CNT);} static struct clocksource arc_counter_timer1 = {	.name   = "ARC Timer1",	.rating = 300,	.read   = arc_read_timer1,	.mask   = CLOCKSOURCE_MASK(32),	.flags  = CLOCK_SOURCE_IS_CONTINUOUS,}; static int __init arc_cs_setup_timer1(struct device_node *node){	int ret; 	/* Local to CPU hence not usable in SMP */	if (IS_ENABLED(CONFIG_SMP))		return -EINVAL; 	ret = arc_get_timer_clk(node);	if (ret)		return ret; 	write_aux_reg(ARC_REG_TIMER1_LIMIT, ARC_TIMERN_MAX);	write_aux_reg(ARC_REG_TIMER1_CNT, 0);	write_aux_reg(ARC_REG_TIMER1_CTRL, TIMER_CTRL_NH); 	return clocksource_register_hz(&arc_counter_timer1, arc_timer_freq);} /********** Clock Event Device *********/ static int arc_timer_irq; /* * Arm the timer to interrupt after @cycles * The distinction for oneshot/periodic is done in arc_event_timer_ack() below */static void arc_timer_event_setup(unsigned int cycles){	write_aux_reg(ARC_REG_TIMER0_LIMIT, cycles);	write_aux_reg(ARC_REG_TIMER0_CNT, 0);	/* start from 0 */ 	write_aux_reg(ARC_REG_TIMER0_CTRL, TIMER_CTRL_IE | TIMER_CTRL_NH);}  static int arc_clkevent_set_next_event(unsigned long delta,				       struct clock_event_device *dev){	arc_timer_event_setup(delta);	return 0;} static int arc_clkevent_set_periodic(struct clock_event_device *dev){	/*	 * At X Hz, 1 sec = 1000ms -> X cycles;	 *		      10ms -> X / 100 cycles	 */	arc_timer_event_setup(arc_timer_freq / HZ);	return 0;} static DEFINE_PER_CPU(struct clock_event_device, arc_clockevent_device) = {	.name			= "ARC Timer0",	.features		= CLOCK_EVT_FEAT_ONESHOT |				  CLOCK_EVT_FEAT_PERIODIC,	.rating			= 300,	.set_next_event		= arc_clkevent_set_next_event,	.set_state_periodic	= arc_clkevent_set_periodic,}; static irqreturn_t timer_irq_handler(int irq, void *dev_id){	/*	 * Note that generic IRQ core could have passed @evt for @dev_id if	 * irq_set_chip_and_handler() asked for handle_percpu_devid_irq()	 */	struct clock_event_device *evt = this_cpu_ptr(&arc_clockevent_device);	int irq_reenable = clockevent_state_periodic(evt); 	/*	 * Any write to CTRL reg ACks the interrupt, we rewrite the	 * Count when [N]ot [H]alted bit.	 * And re-arm it if perioid by [I]nterrupt [E]nable bit	 */	write_aux_reg(ARC_REG_TIMER0_CTRL, irq_reenable | TIMER_CTRL_NH); 	evt->event_handler(evt); 	return IRQ_HANDLED;}  static int arc_timer_starting_cpu(unsigned int cpu){	struct clock_event_device *evt = this_cpu_ptr(&arc_clockevent_device); 	evt->cpumask = cpumask_of(smp_processor_id()); 	clockevents_config_and_register(evt, arc_timer_freq, 0, ARC_TIMERN_MAX);	enable_percpu_irq(arc_timer_irq, 0);	return 0;} static int arc_timer_dying_cpu(unsigned int cpu){	disable_percpu_irq(arc_timer_irq);	return 0;} /* * clockevent setup for boot CPU */static int __init arc_clockevent_setup(struct device_node *node){	struct clock_event_device *evt = this_cpu_ptr(&arc_clockevent_device);	int ret; 	arc_timer_irq = irq_of_parse_and_map(node, 0);	if (arc_timer_irq <= 0) {		pr_err("clockevent: missing irq");		return -EINVAL;	} 	ret = arc_get_timer_clk(node);	if (ret) {		pr_err("clockevent: missing clk");		return ret;	} 	/* Needs apriori irq_set_percpu_devid() done in intc map function */	ret = request_percpu_irq(arc_timer_irq, timer_irq_handler,				 "Timer0 (per-cpu-tick)", evt);	if (ret) {		pr_err("clockevent: unable to request irq\n");		return ret;	} 	ret = cpuhp_setup_state(CPUHP_AP_ARC_TIMER_STARTING,				"clockevents/arc/timer:starting",				arc_timer_starting_cpu,				arc_timer_dying_cpu);	if (ret) {		pr_err("Failed to setup hotplug state");		return ret;	}	return 0;} static int __init arc_of_timer_init(struct device_node *np){	static int init_count = 0;	int ret; 	if (!init_count) {		init_count = 1;		ret = arc_clockevent_setup(np);	} else {		ret = arc_cs_setup_timer1(np);	} 	return ret;}CLOCKSOURCE_OF_DECLARE(arc_clkevt, "snps,arc-timer", arc_of_timer_init);